QDI P6I440LX/DP, Руководство пользователя

Страница: 17 / 45

Chapter 3
3 - 5
adapter.
This RAID port option by adding the Adaptec ARO-1130
adapter can support:
Bus Master DMA
Up to 133 Mbyte/Sec Burst rate
RAID 5, 1, 0 and 0/1
Fully Netware 3.11, 3.12, 4.x & WinNT
3.51/4.0 supported by Adaptec
ISA 1, 2, 3 General using for ISA cards.
DIMM 1-2, 3, 4 Memory for SDRAM or EDO.
Narrow SCSI For ultra narrow SCSI peripherals. Be sure the red side of
the cable should align to the end of the connector which is
signed with " ".
Wide SCSI For ultra wide SCSI peripherals.
Note1 :Ultra narrow SCSI peripherals and ultra wide SCSI
peripherals can be used at the same time.
Note2 :You must assign a different SCSI ID to each device
on the SCSI bus connected to the system board. See your
SCSI device documentation for directions on how to
determine the ID and change it.
Ultra Wide SCSI devices connected to this mainboard’s
SCSI connector can be assigned ID from 0 to 15 (for 68
pin Wide SCSI connection). Normally, ID7 will be used
by the on-board host.
The SCSI ID0 is the best one for SCSI hard disk to be
used as your computer’s boot device; ID1 is best reserved
for a secondary SCSI hard disk. (Only when you use the
SCSI hard disks and devices.)
ATX Power ATX power supply connector.