Manual for LegenX 8
Line-in jack, Microphone-in jack, Speaker-out jack and
MIDI/Joystick connector
The Line-in jack can be connected to devices such as a cassette or minidisc player for
playback or recording. The Microphone-in jack can be connected to a microphone for
voice input. The Speaker-out jack allows you to connect speakers or headphones for
audio output from the internal amplifier.
The MIDI/Joystick connector allows you to connect a game joystick or a MIDI device.
ATX Power Supply Connector & Power Switch (POWER)
Be sure to connect the power supply plug to this connector in its proper orientation. The
power switch (POWER) should be connected to a momentary switch. When powering up
your system, first turn on the mechanical switch of the power supply (if one is provided),
then push once the power button. When powering off the system, you needn’ t turn off the
mechanical switch, just
Push once
*
the power button.
Note: * If you change “soft-off by PWR-BTTN” from default “Instant-off” to “Delay
4 Secs” in the “POWER MANAGEMENT SETUP” section of the BIOS, the power
button should be pressed for more than 4 seconds before the system powers
down.
Hard Disk LED Connector (HD_LED)
The connector connects to the case’ s IDE indicator LED indicating the activity status of
IDE hard disk.
Reset Switch (RESET)
The connector connects to the case’ s reset switch. Press the switch once, the system
resets.
Installation Instruction
6
MIDI/Joystick
Speaker out
Line in
Microphone in
POW ER
5V 5V -5V GND GND GND PSON
GND -12V 3.3V
12V 5VSB PS-OK GND 5V GND 5V GND 3.3V 3.3V
ATX Power Supply Connector
1
20
