Manual for LegenX 8
Infrared Header (IrDA)
This connector supports wireless transmitting and receiving. If using this function, set
“ Serial Port 2 Mode” to IrDA or ASKIR and configure the settings from the “ INTEGRATED
PERIPHERALS” section of the BIOS.
Fan Connector (CPUFAN, CHSFAN)
These two fans are controllable. They will be automatically turned off after the system
enters suspend mode. You also can choose not to turn the CPUFAN off by setting “CPUFAN
Off In Suspend” as Disabled in the “POWER MANAGEMENT SETUP” section of the BIOS.
Wake-Up On LAN (WOL)
Through the Wake-Up On LAN function, a wake event occurring from the network can
wake up the system. If this function is to be used, please be sure an ATX 2.01 power
supply of which 5VSB line is capable of delivering 720mA, and a LAN adapter which
supports this function are used. Then connect this header to the relevant connector on the
LAN adapter, set “Resume by Ring/LAN” as Enabled in the “POWER MANAGEMENT SETUP”
section of the BIOS. Save & exit, then boot the operating system once to make sure this
function takes effect.
Installation Instruction
8
VCC
IRRX
GND
IRTX
NC
VCC
FAN GND
CHSFAN
+12V
SENSE
FAN GND(Controllable)
+12V
SENSE
CPUFAN
1
+5V standby
GND
Signal for waking up (active high)
