Chapter 2
K8N4/K8N4U
13
Wake-Up On LAN (WOL)(optional)
Through the Wake-Up On LAN function, a wake event occurring from the network can
wake up the system. If this function is to be used, please be sure an ATX 12V power
supply and a LAN adapter which supports this function are used. Then connect this
header to the relevant connector on the LAN adapter, set “WOL(PME#) From Soft-off” as
Enabled in the “POWER MANAGEMENT SETUP” section of the CMOS SETUP. Save and
exit, then boot the operating system once to make sure this function takes effect.
WOL(optional)
Signal for waking up
+5V standby
GND
1
Wake-Up On Internal Modem (WOM)(optional)
Through this function, the system which is in the suspend or soft-off status can be
waked up by a ring signal received from the internal modem. When this function is used,
be sure an internal modem card which supports this function is used. Then connect this
header to the relevant connector on the modem card, set “WOR(RI#) From Soft-off” as
Enabled in the “Power Management Setup” section of the CMOS SETUP. Save and exit,
then boot the operating system once to make sure this function takes effect.
WOM
Signal for waking up(active low)
+5V standby
GND
1
