QDI J6A, Руководство пользователя

Страница: 13 / 60

7
Manual for J6A series
Chapter 2
ATX Power Supply Connector & Power Switch( POWER SW )
Be sure to connect the power supply plug to this connector in its proper orientation. The
power switch ( POWER SW ) should be connected to a momentary switch . When powering
up your system, first turn on the mechanical switch of the power supply (if one is provided),
then push once the power switch. When powering off the system, you needn’t turn off the
mechanical switch, just
Push once * the power button.
Note: If you change “soft-off by PWRBTN” from default “Instant-off” to “Delay 4
Sec” in the “POWER MANAGEMENT SETUP” section of the BIOS, the power button
should be pressed for more than 4 seconds before the system powers down.
ACPI LED Connector (ACPI LED)
When the system is in S0 status, the LED is green on. When the system is in S1 status, the
LED is green blink. When the system is in S4/S5 status, the LED is off.
HDD
LED
(+)
HDD
LED
(-)
POWER SW
VCC
NC
GREEN
(-)
LED
(+)
POWER GND
SPEAKER
GND NC SPKDATA
RESET
RESET GND
NC
ACPI_LED
SPEAKER
A C P I
LED
RESET
POWER
SW
HD_LED
POWER SW
ATX Power Supply Connector
3.3V 3.3V GND 5V GND 5V GND PS-OK 5VSB 12V
3.3V -12V GND PSON GND GND GND -5V 5V 5V
1
20
1
J6Aen.p65 02-7-29, 9:55 7