QT-5000 & Remote Control Audio System
Revision: 6
QT-5000 and RCAS User Manual v6.docx
Page 6 of 30
Q5X Systems, Inc. 2012
Module Integration into Host End Products
The QT-5000 Module Transmitter has been designed by Quantum5X Systems Inc. to be used exclusively
by Quantum5X as a building block for their wireless audio transmitter products. The module, as
designed, is a standalone unit that is ready for integration into final form factor with the limitation for
portable use as specified in RF Exposure compliance. For proper usage of the module, the module
integrator must ensure that the input power and input audio signal do not exceed the specified limits as
outlined in the specification section. Failure to do so will result in damage to the module.
QT-5000 Module Mounting
Mounting of the QT-5000 module must provide a solid, reliable, mechanical connection between the
module and the tap shoe. If the QT-5000 module is not securely fastened to the tap shoe, it may
become separated from the shoe during dancing and could cause harm to the wearer, the audience
member or the module. Below are two sets of instruction for mounting to two different styles of
shoes: high heel and a low heel style of shoe. In each case, it is important to maintain the minimum
10 mm antenna spacing of the module from the wearer.
High Heel Tap Shoe
The tap shoe first needs to be modified to allow the QT-5000 module to be fastened to the shoe.
Figure 3 -
Mounting Holes Drilled into
Four holes are drilled into the sole of the shoe, and up through the foot bed.
Figure 4 -
T-Nuts installed into sole
