QT‐AD10 Module
7
Eliminates the need to physically handle the transmitters after they are installed on the user.
Remotely turn the transmitter’s On/Off to conserve battery life when not in use.
Provides the ability to change the frequency in the event of RF interference.
Provides the ability to change the microphone’s gain if the audio is too loud or soft.
Features
Performance
20 Hz to 20 kHz range with flat frequency response
Automatic input staging optimizes gain setting
AES 256‐bit encryption‐enabled for secure transmission
>120 dB dynamic range
100 meter (300 feet) line‐of‐sight operating range
Selectable modulation modes optimize performance for spectral efficiency
o
Standard – optimal coverage, low latency
o
High density – dramatic increase in max system channel count
Built‐in tone generator and RF markers to facilitate walk‐testing
Switchable Power Levels = 2/10/20mW (region dependent)
Design
Single pin Lemo audio connector
Rugged metal construction
Flexible ¼ wave antenna
Working with the AD10 Module
Out‐of‐the‐Box Setup
Ensure the QT‐AD10 has a sufficient charge level by first connecting a micro USB charger and check
for charge levelwith a QG‐N3 gateway or QG‐H2MicCommander remote that the charge level is
adequate for your intended use.
Storage Mode
When the AD10 Module is in Storage mode the transmitter will be completely off and will not
respond to any commands from the QG‐H1 remote or QG‐N3 gateway. If the transmitter was set to
Storage mode , the only way to bring it out of storage mode is to connect the module to a usb charger
to bring it out of storage mode.
