QT‐AD10 Module
6
AD10 Transmitter Module
Introduction
AD10 series bodypack transmitters deliver impeccable audio quality and RF performance with wide‐
tuning, High Density (HD) mode, and encryption. The transmitter module features durable metal
construction, and single pin Lemo connector.
The Q5X remote control system is referred to as
RCAS
,
R
emote
C
ontrol
A
udio
S
ystem. Q5X pioneered
wireless remote control for transmitters in 2009. Since this is a wireless control system, it will work
through walls, clothing, uniforms, costumes, etc. and over longer distances than non‐RF types of
transmitter control systems on the market. RCAS consists of 4 main components;
1) a QT‐AD10 series transmitter,
2) the MicControl software,
3) the QG‐N3 MicCommander, a network enabled controller,
4) the QG‐H2 MicCommander, a hand held remote control, with USB connectivity
The
QG‐H2
MicCommander is a handheld, stand alone device used to control the QT‐AD10 series of
Q5X audio transmitters, such as the QT‐AD10 PlayerMic. It can also control legacy QT‐5000
transmitters. The QG‐H2 allows the user to view, monitor and make adjustments to any QT‐AD10
transmitter within the control range. It can monitor and/or adjust; the transmitter power state ON or
OFF, RF power, UHF frequency, microphone muting and mic gain, groups, transmitter naming, and
other operational parameters can be remotely configured using the QG‐H2 without physical access to
the transmitter.
The
QG‐H2
can control up to 32 transmitters as a stand‐alone device.
USB connectivity allows the
QG‐H2
to be connected to a laptop or PC running Windows 7 and above.
This connection allows the use of the
MicControl
software on the PC to control enhanced features of
the transmitters including the ability to name transmitters. Naming transmitters makes it much
easier to manage the system, for example instead of looking at a list of serial numbers like 10223 or
20567 you can now name them Player1 or Actor 2 or Joes Mic.
The
RCAS
system can also be networked and uses the network enabled
QG‐N3
to remotely control
the
QT‐AD10
series of transmitters via
MicControl
software which can be installed on a Windows PC
or laptop. Multiple QG‐N3 units can be added to a network to manage large area installations.
The
MicControl
software can control over 300 transmitters for larger installations.
The
QG‐H2MicCommander
operates independently from any other gateway or computer. It
communicates one‐to‐one with each transmitter and allows access to all necessary settings through a
simple interface. It can over ride any setting made by the
MicControl
software and vice versa.
The
QG‐H2 and QG‐N3
offer the following benefits:
