User Manual
4. Unicast service configuration
38
www.qtech.ru
4.2.1.8.
VLAN Layer 3 sub-interface Configuration
This command is used to create the VLAN interface from the global configuration mode and the
VLANIF mode. Use this command when you need to configure a virtual layer three interface in VLANIF
mode.
OLT (config)# interface vlanif102
OLT (config-vlanif102)# ip address 12.0.0.1/24
OLT (config-vlanif102)#exit
4.3.
PON port VLAN
PON port VLAN is unnecessary to configure, after configuring VLAN in uplink interface and ONU, OLT
will automatically add PON port into the corresponding VLAN.
4.4.
Configure different service types
4.4.1.
Passthrough service
QTECH OLT supports full Passthrough and VLAN passthrough mode, the full passthrough includes all
the packets, while VLAN passthrough refers to specific VLAN packets.
4.4.1.1.
Full pass-through configuration
Configure uplink port:
OLT (config) #interface xe1 / 1
OLT (config-xe1 / 1) #switchport mode trunk
OLT (config-xe1 / 1) #switchport trunk tag 2-4094
Add T-CONT and bind GEM Port:
OLT (config) #interface gpon-onu1 / 1: 1
OLT (config-gpon-onu1 / 1: 1) # tcont 1 profile 100
OLT (config-gpon-onu1 / 1: 1) # gemport 1 tcont 1
Configure Full passthrough service:
OLT (config-gpon-onu1 / 1: 1) # service-port 1 gemport 1
Configure the remoteONU passthrough mode:
OLT (config-gpon-onu1 / 1: 1) # remote service 1 gem 1
OLT (config-gpon-onu1 / 1: 1) # remote uni eth_1 / 1 vlan-mode
transparent
Содержание OLT-QSW-9010
Страница 1: ...USER MANUAL www qtech ru QSW 9010 CLI Configuration user manual QSW 9010 ...
Страница 23: ...User Manual 2 Basic service configuration 23 www qtech ru ...
Страница 71: ...User Manual 6 QoS service configuration 71 www qtech ru ...
Страница 96: ...User Manual 12 Port statistics and PM statistics 96 www qtech ru ...