8/16 Channel Digital Video Recorder
53
Enter the IP address, factory default is 192.168.1.111, the first 3 numbers have to match your computer’s
IP, change them if they do not. Make sure the Subnet and Gateway in the network settings on the DVR
are the same as on your computer, if not, change the settings in the DVR to match your computer. You can
find your computer’s IP, Subnet, and Gateway by going to the start button on your computer, clicking on
“Run”, type CMD, click OK, and type IPCONFIG at the prompt. Check default set or input values for AV
Port, Command Port, Channel Enable, Video, etc. and click OK.
Click the “Connect” button in the main window. The Logon window appears. Enter the password and
click OK. The password is the same as the DVR password, which by default is 0000.
If the connection to the DVR is established the Connect OK window appears. Click the “OK” button,
and then click on the “Play” button (the clipboard image in the upper right hand corner of the program).
Remote Access:
When users access the DVR on a remote computer through the Internet, they need to
open ports 5000-5001 (default which can be changed on the DVR) on the router the DVR is connected to.
Refer to the router manual, or go to
http://www.portforward.com
, click on the “Routers” link, click on the
model number of your router, and on the page for that model click on the “Default Guide” link to get
instructions on how to forward ports for your router. To access the DVR remotely you will also need to
put the IP address of the network the DVR is attached to into Netviewer. You can get this by going to the
website
http://myipaddress.com
from a computer attached to the same router as the DVR. Enter this
address into the IP window in Netviewer and enter the default password for the DVR which is 0000 by
default.