Q Acoustics M3, Руководство пользователя

Страница: 13 / 288

13
a. Power
Press this button to turn the Unit STANDBY ON / OFF.
b. Source select
Press this button to manually select the audio input source.
The status LED will change colour accordingly.
Note:
When the Source button is used, the Unit will stay on the
selected source and disable the automatic source selection.
ASS functions will be reactivated after the Unit has been put
in STANDBY.
c. Volume Up / Down
Press VOL + to increase the volume. Press VOL – to reduce
the volume.
d. Mute
Press this button once to MUTE the Unit. Status LED will SLOW
FLASH to indicate MUTE. Press this button again to un-mute
the Unit.
Note:
Long press of Mute will also put the Unit into STANDBY.
e. EQ
Short press the EQ button to toggle MoviEQ On and Off.
(see section 9.10.)
Caution:
When replacing the lithium battery in the remote, make sure that the replacement battery is
inserted with the correct polarity. Place the battery so that the positive (+) side faces up with
the tray held so the surface with the dot and (+) is facing up.
Remote Control battery replacement
a. Push small tab
toward battery slot. b. Pull battery
drawer out. c. Insert battery
with “+” side up
and slide drawer
back into remote. d. Slide drawer
back into remote.
Caution:
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent battery type (CR2025)
Do not expose batteries to excessive heat such as direct sunlight, fire or the like.
Dispose of dead batteries in accordance with local regulations.
7. Remote Control
a
b
c
d
e