1 0
USING THE OCTAGON II AFTER PROGRAMMING
10.1.
Cleaner Functions.
10.1.1 Full Setting the Panel.
To full set the system enter the cleaner code
.
The full set symbol
will be displayed until the panel sets.
10.1.2 Part Setting the Panel.
To part set the system enter the cleaner code
followed by
for part set A
for part set B
for part set C
A part set symbol
,
OR
will be displayed until the panel sets.
10.1.3 Unsetting The Panel.
To unset the system enter the cleaner code
.
The keypad display will show
which indicates that the system is not completely unset. Any cleaner zones which
are activated at this time will create a full alarm.
10.1.4 Activating Personal Attack (P.A.) Alarm.
To activate the P.A. alarm enter
or
10.1.5 Turning Chime ON and OFF.
With the panel in day mode enter
.
As this feature is turned on a two tone chime will be given by the remote keypads and any extension speakers (if fitted).
With chime enabled any zones programmed to chime by the Master user will cause the same two tone chime to be given
by the remote keypads and speakers. The chime zone number will also be displayed on the RKP. A chime caused by a
RKP remote zone will be displayed as
To turn off the chime facility enter
.
10.1.6 Cancelling a Power Failure.
In day mode if the mains supply is interrupted the tamper LED and
will flash.
A tamper tone will be generated by the remote keypad. To cancel this tamper alarm enter any user code.
10.1.7 Communicator Line Failure.
If the communicator is used which incorporates a line fail output this output may be connected to the line fail input on the
control panel. If this input is activated (switched to 0Volts from 12Volts) then
will flash on the RKP, the line fail LED
will illuminate and a tone generated.
Any subsequent alarm activation will cause the bell delay to be overridden, causing the external sirens to operate
immediately.
10.1.8 Duress Code.
If the last two digits of a user code are reversed when arming or disarming the panel, the digital communicator personal
attack output is activated. The correct code must be entered to reset the P.A. communicator output.
e.g.
Code
Duress code
22
All manuals and user guides at all-guides.com
