(4) Level Discrimination Modes
(4) Modes
Indication
Sound
TARGET ID
Indication
The Eliminated Metals
Initial state
High tone
Not illumined
Can’t eliminate any metals
Press “MODE” Until Set
Low tone
Iron is illumined
NOTCH
Ⅰ
and Iron are
eliminated
Press “MODE” Until Set
Medium tone
Mid range is illumined
NOTCH
Ⅱ
,Pull-tabs and
nickel coins are eliminated
Press “MODE” Until Set
Low and medium
tones
Iron and Mid range
are all illumined
NOTCH
Ⅲ
, Iron, pull-tabs
and nickel coins are
eliminated at the same time
Press “MODE” Until Set
High tone
Not illumined
Can’t eliminate any metals
and is in ALL METAL mode
The above four modes are all activated in the metal detector motion mode, it means you should move the
search coil at a certain speed and 'painting' pattern, in order to detect and discriminate optimally.
PINPOINT Mode
Press and hold down the red “PINPOINT” button on the handle, the detector will switch to non-motion
mode, and it no longer has the discrimination ability. Now, the PINPOINT cursor will be displayed and the
target identification cursor will be rendered useless. The sensitivity cursor turns into signal strength
indication cursor.
Note:
The times of the indication tone is in correlation with the sensitivity level, which means when the
sensitivity is at the fourth level, the detector should also sound four times.
When operating the metal detector, be sure to avoid close proximity with familiar and known metal objects -
as you intend to find unknown or hidden metal objects. The metal detector is also prone to interference from
electronic device and frequency wave generating technologies. Avoid electro-magnetic interference and
keep the unit away from cellphones, smart devices, TVs, computers, etc.
www.PyleAudio.com
