www.proindecsa.com / [email protected]
OPERATING AND MAINTENANCE MANUAL
ELECTRIC CIRCULATOR PUMP SERIES PC & PCB
18
18.
How to adjust the position of the junction box; The above operations may only be carried out by
qualified personnel.
Max
endurance
pressure:
XP
、
XPS series 1.0Mpa(10bar)
BPS series 0.3Mpa(3bar)
Make sure that the power
switch is turned off in case
of any necessary service.
Service or repair may only be started after the pump has
cooled down to prevent injury from heat or hot liquid.
Separate the engine section and the
pump section.
The junction box cannot be located in position
“X” (as shown in the figure).
Rotate the motor
section until the
junction box is
in the right place
and screw the
four bolts until
the motor and
pump are com-
pletely sealed
and connected.
The location of
the junction box
can be adjusted
according to
the position of
different types of
installation. Be-
fore adjustment,
confirm that the
power switch
and water source
switch are turned
off when the
pump cools down
unscrew the four
points connec-
ting the motor
and pump body.