PURSUIT OS 375, Руководство пользователя

Страница: 48 / 146

OS 375
48
SINK AND SHOWER OPERATION
To use the galley sink, head sink or shower, turn on the fresh water system. Some minor variations in the water
temperature and pressure may occur as the pump cycles. The sinks drain overboard.
Water drains from the shower to a sump pump system located in the bilge below the cabin floor. An automatic
float switch in the shower sump controls the pump. After showering, let the cold water flow for a period of
time to flush the drainage system of soap residue. It is essential that the shower drain strainer is cleaned
regularly and the sump is inspected periodically for accumulated debris that needs to be removed.
WATER HEATER
The water heater is located below the cabin lounge. All heaters have an AC element that is thermostatically
controlled at the heater and activated by a circuit breaker located in the AC panel. A high pressure relief valve
protects the system from excessive pressure. Always make sure all air is purged from the water heater and
lines before activating the water heater breaker. Refer to the water heater owner’s manual for additional
information.
DO NOT SUPPLY CURRENT TO AN EMPTY WATER HEATER. DAMAGE TO THE
HEATER WILL RESULT. THE SYSTEM MUST BE FILLED AND PRIMED BEFORE
USING THE WATER HEATER.
SHORE WATER CONNECTION
The shore water connection allows the direct connection of the water system to a shore side water supply. This
provides the system with a constant supply of fresh water and minimizes the pressure pump operation. A
female inlet fitting is mounted in the starboard side of the splashwell.
To use shore water, connect a hose from the shore water faucet to the shore water fitting on the boat. Next,
turn on the shore water. The pressure pump will not run and the water in the boat’s water tank will not be used.
The water tank will not be filled by connecting to shore water.
DO NOT MODIFY OR CHANGE THE SHORE WATER INLET CONNECTOR WITH AN-
OTHER TYPE WITHOUT CONSULTING PURSUIT CUSTOMER RELATIONS OR YOUR
DEALER. THE USE OF THE WRONG TYPE OF INLET CON-
NECTOR CAN DAMAGE THE FRESH WATER SYSTEM.
5.2 Raw Water Washdown
The raw water washdown system pump is supplied by hoses connected to a ball
valve and a thru-hull fitting located in the bilge.
OPERATION
Always make sure the ball valve is open before attempting to operate the raw water
washdown system. The pump is activated by the washdown switch located on the
helm. When activated, the pressure switch will automatically control the pump. As
the pressure builds in the washdown hose, the pump will shut off. When the
washdown hose is in use and the pressure drops, the pump will turn on. Turn the switch off when the washdown
is not in use.
Washdown Hose
Connector (typical)