PURSUIT 3070 OFFSHORE, Руководство пользователя

Страница: 72 / 150

3070 OFFSHORE
THE TRANSOM DOOR SHOULD BE CLOSED AND PROPERLY LATCHED WHEN-
EVER THE ENGINE(S) ARE RUNNING. NEVER OPEN THE TRANSOM DOOR
WHILE UNDERWAY OR IN ROUGH SEA CONDITIONS. IN CERTAIN SITUATIONS,
AN OPEN TRANSOM DOOR COULD ALLOW A SUBSTANTIAL AMOUNT OF WA-
TER TO ENTER THE COCKPIT CREATING A POTENTIALLY DANGEROUS CON-
DITION.
OPERATING THE BOAT UNDER POWER WITH THE TRANSOM DOOR OPEN MAY
ALLOW PERSONS TO FALL OVERBOARD AND INTO BOAT PROPELLERS OR TO
BE LOST IN OPEN WATER. ALWAYS CHECK TO MAKE SURE THE TRANSOM
DOOR IS PROPERLY CLOSED AND LATCHED BEFORE STARTING THE ENGINES
AND NEVER OPERATE THE BOAT UNDER POWER WITH THE TRANSOM DOOR
OPEN.
Helm and Electronics Locker
The helm and engine controls are located on the rear of the center console. Molded-in electronics
storage is located forward of the engine controls. Four cup holders and a stern facing jump seat
are located to the starboard side of the helm.
The top section of the console is hinged and opens to provide access to service the helm
equipment or install electronics. The console cushion backrests also can be removed to expose
access holes that make installing or servicing electronics easier. To open the helm portion of
the console, release the clamps on the front of the console. Then activate the electric helm tilt
ram with helm tilt switch located near the clamps at the front of the console. The top of the console
will be tilted aft to expose the underside of the helm.
If the electric helm lifter fails, the helm can be opened manually by removing the quick release
pin at the top or bottom of the helm tilt ram. To access the pin with the helm closed, open the
access hatch below the helm accessory switches and pull the ring on the pin while someone holds
the helm in the closed position or with the helm latches in place. Be careful, the helm is heavy
and will open suddenly when the pin is released.
The tilt ram is an important part of the helm latching system. Never operate the boat unless the
tilt ram is completely assembled and operating properly. You also should make sure the clamps
are properly secured when the helm is closed.
Note: The adjustable seat must be adjusted to the full aft position and the rod locker
bridge deck hatch must be completely closed before opening the helm. A safety
switch in the seat prevents the helm tilt system from operating unless the seat is
adjusted to the full aft position.
9-5