PURSUIT 3070 OFFSHORE, Руководство пользователя

Страница: 69 / 150

3070 OFFSHORE
9-3
Windshield
The Pursuit 3070 Offshore is equipped with an optional vented heavy duty aluminum windshield
with tinted glass and built in hand rails. The windshield is equipped with an opening vent panel
on each side of the windshield. To open the vent, release the locking T-handle and rotate it
outboard until it locks in place. To prevent damage to the vent glass, do not leave the T-handle
in the unlocked position. The front and side wing panels are tempered safety glass. The curved
glass panels on the port and starboard side of the windshield are made of tinted acrylic plastic
glass.
Acrylic glass scratches easily. Never use a dry cloth or glass cleaning solutions on acrylic. Use
a soft cloth and mild soap and water for routine cleaning. Solvents and products containing
ammonia can permanently damage acrylic. Please refer to the Routine Maintenance chapter for
more information on the proper care and maintenance of acrylic plastic glass.
9.2 Hull
Swim Platform
Your Pursuit is equipped with an integral swim platform and engine mounting system located
in the stern of the boat. There are three inspection deck plates in the transom engine well to
provide access to the stern bilge and engine mounting bolts. Always make sure these plates are
secure before operating your boat.
Boarding Ladder
The boarding ladder is mounted to the rear of the stern bait
and tackle rigging station when it is in the stored position.
To use the ladder, remove it from the storage clips and slide
the studs into the special bracket on the port side of the
transom. The ladder floats and must be secured in the
boarding position by turning the cam lock on the ladder so
it catches the bottom of the transom ladder bracket. The
ladder must be removed from the transom bracket and
properly secured to the storage clips before starting the
engine(s).
MOVING PROPELLERS ARE DANGEROUS. THEY CAN CAUSE DEATH, LOSS OF
LIMBS, OR OTHER SEVERE INJURY. DO NOT USE THE SWIM PLATFORM OR
SWIM LADDER WHILE THE ENGINE(S) ARE RUNNING. STOP THE ENGINE(S) IF
DIVERS OR SWIMMERS ARE ATTEMPTING TO BOARD. ALWAYS REMOVE AND
PROPERLY STORE THE LADDER BEFORE STARTING THE ENGINE(S).
Trim Tabs
The trim tabs are recessed into the hull below the swim platform. The trim tabs are an important
part of the control systems. Please refer to the Helm Control Systems chapter for detailed
information on the trim tabs.
Boarding Ladder