PURSUIT 2570 offshore, Руководство пользователя

Страница: 88 / 236

2570 Offshore
88
Snaps should be lubricated periodically with petroleum jelly or silicone grease. Zippers should be lubricated
with silicone spray or paraffin.
The bimini top, side curtains, clear connector, back drop and aft curtain must be removed when trailering.
Canvas enclosures are not designed to withstand the extreme wind pressure encountered while trailering and
will be damaged. Always remove and properly store the enclosure before trailering your boat.
Do not operate engines, fuel consuming heaters or burners with the canvas enclosures closed. The cockpit
must be open for legal ventilation and to prevent the possible accumulation of carbon monoxide fumes, which
could be lethal.
CARBON MONOXIDE IS A LETHAL, TOXIC GAS THAT IS COLORLESS AND ODORLESS.
IT IS A DANGEROUS GAS THAT WILL CAUSE DEATH IN CERTAIN LEVELS.
11.4 Cabin Interior
The cabin interior can be cleaned just like you would clean a home interior. To preserve the teak woodwork,
use teak oil. To maintain the carpeting, use a vacuum cleaner. Because air and sunlight are very good cleansers,
periodically put cushions, sleeping bags, etc. on deck, in the sun and fresh air, to dry and air out. If cushions
or equipment get wet with saltwater, remove and use clean, fresh water to rinse of the salt crystals. Salt retains
moisture and will cause damage. Dry thoroughly and reinstall.
Vinyl headliner material should be cleaned periodically as explained in the previous section. Avoid using
products containing ammonia, bleach or harsh chemicals as they can shorten the life of vinyl.
If you leave the boat for a long period of time, put all cushions on their sides, open all interior cabin and locker
doors and hang a commercially available mildew protector in the cabin.
ALWAYS READ THE LABEL CAREFULLY ON MILDEW PROTECTORS. REMOVE THE
PROTECTOR AND ALLOW THE CABIN TO VENTILATE COMPLETELY BEFORE USING
THE CABIN.
11.5 Bilge
To keep the bilge clean and fresh, use a commercial bilge cleaner regularly. Follow the directions carefully.
All exposed pumps and metal components should be sprayed periodically with a protector to reduce the
corrosive effects of the high humidity always present in these areas.