Puro PURO-35T, Инструкция по установке, эксплуатации и обслуживанию, Страница: 5 / 20

5
SECTION III. PREPARATION
A. Major System Components
The following components comprise the R.O.
Drinking Water System. (Refer to Fig. 1, below
for general system layout.)
• An R.O. Manifold assembly.
• Housings and Housing O–rings.
• A Drinking Water Holding Tank.
• A Dispensing Faucet with Water Quality
Monitor Assembly.
• A Feed Water Saddle Valve.
• A Drain Clamp.
• Plastic Tubing and tube connectors.
• A Reverse Osmosis Membrane sealed in a
plastic bag.
• A Sediment/Carbon Prefilter, shrink wrapped.
• An Activated Carbon Post Filter, shrink
wrapped.
• An In–Line Activated Carbon Post Filter,
shrink wrapped.
• Other items necessary for installation may
include wood screws or machine screws and
nuts for mounting the manifold, or concrete
anchors for hanging on basement wall.
Additional tubing or tube connectors. Plastic
wire ties for organizing tubing.
TYPICAL PURO-35T UNDER SINk INSTALLATION DIAGRAM
Figure 1
Dispensing Faucet with air gap
Drain
clamp
Drain
(3/8" Black)
prODuct
(3/8" Blue)
Drain
(1/4" Black)
inlet
(1/4" red)
tanK
(3/8" Yellow)
DrinKing
water
hOlDing tanK
hOlDing tanK
shutOFF ValVe
(Open position)
FeeD water
saDDle ValVe
(cold water line Only)
lOcate Drain clamp
aBOVe "p" trap
4" min
reVerse
OsmOsis
memBrane
hOusing
actiVateD
carBOn
pOst Filter
hOusing
seDiment/
carBOn
preFilter
hOusing
1
3
8
9
10
(1/4" Yellow)
pOlYtuBe
tee
7
water qualitY mOnitOr
Faucet Base
2
water qualitY mOnitOr caBle
rO maniFOlD
5
in-line actiVateD
carBOn pOst Filter
6
cOVer
4
RED
BLA
CK
YEL
LOW
IN
DRA
IN
OUT
DRA
IN
RES
TRIC
TOR
See Page 11
Close-up of Manifold