Puretec SH SERIES, Руководство пользователя

Страница: 6 / 12

6 Installation & Operation Manual Copyright © Puretec Pty Ltd 2018
Installation Procedure
Cartridge Installation/Changeout
To change the filter cartridges adhere to the following procedure.
1. Close ballvalve to prevent water flow.
2. Relieve water pressure by operating faucet lever.
3. Unscrew filter housing bowl using the spanner wrench and discard cartridges. When
removing housings place a container underneath to catch any spillage.
4. Cleanse the inside of the housing using warm water. Check O-Ring and lubricate
with food grade silicone lubricant or similar. Replace O-Ring if kinked or damaged.
(Part No: FPOR)
5. Install new cartridges and replace housing screwing them up HAND TIGHT ONLY.
Sediment filter is on the inlet side and chemical on the outlet side.
6. Reset LED indicator by following instructions on page 8.
7. Restore water supply & check for leaks, rectifying them, if any, before leaving the
unit.
After installing cartridges flush unit for 5 - 10 minutes.