3
Quick Twist Undersink Water Filter System with High Loop LED Faucet
Installation
This system comes complete with an installation kit enabling it to be connected to 15mm (½”)
male thread. This product must be installed in accordance with local plumbing regulations by
a licensed plumber.
Installation requirements
1 15mm (½”) Cold water line - mains only
2 Supply pressure: 100-875 kPa.
3 Supply temperature 3° - 38°C.
4 Suitable location for faucet.
Alternative fittings may be required if being connected to anything other than 15mm
(½”) copper pipe. No electrical or drainage requirements needed.
Installation Procedure
1. Select suitable location that is close to the point of filtered water delivery (eg. sink).
Remember to allow access room for changing filters and a suitable place where water
spillage will not cause damage. Location should not be in direct sunlight.
2. Isolate water supply. Uninstall the connections on the cold water line and connect the
Smart Tee
™
. Reinstall the previous connection to the tee valve.
3. Connect the pressure limiting multivalve to the Smart Tee
™
with a length of white
tubing.
4. Choose the best position for the faucet, taking into consideration height of jugs etc.
and also the drainage of any spills. Then drill a
0
12.5mm hole and install the faucet
as in step 5.
5. To install faucet, place the escutcheon, o-ring, base upholder into the faucet (see
figure 3). Insert the faucet into the hole in sink or bench. Slip the large plastic washer
and lock washer onto threaded end of faucet and screw on nut and tighten making
sure faucet is correctly positioned on top.
6. Reset LED indicator by following instructions on page 6.
7. Install filter cartridge by positioning it in the desired location, marking the position of
fixing hole and fixing with bracket screw. (QT18 Series can be mounted horizontally
or vertically) Allow room for the connecting tubes. Ensure flow arrow on cartridge is in
direction of waterflow.
8. Fit tubing into connectors (for quick-connect fittings see fig 2). Allow slack in the
tubing.
Installation