PUREGLOW XPG170, Инструкция по установке и обслуживанию, Страница: 2 / 16

2
YOUR FIRE
XPG fires are visual effect fires with LED lighting and remote control. They are available
with several different fascia trims and frets.
The general fitting instructions refer to all models.
SECTION 1: UNPACKING, ELECTRICAL INSTALLATION AND
GENERAL SAFETY
GENERAL
Unpack the fire carefully and retain the packaging for possible future use, for example in
the event of moving home or returning the fire for repair to your supplier. Remove any
plastic protection film and transit tape.
The fire incorporates an effect which can be used with or without heating so that the
comforting effect may be enjoyed at any time of the year; using the flame effect only
requires minimal electricity.
Before connecting the heater check that the supply voltage is the same as that stated on
the heater.
Please note: When used in a very quiet environment, where background noise is very
low, it may be possible to hear a sound which is related to the operation of the visual
effect; this is normal and should not be a cause for concern.
ELECTRICAL INSTALLATION
THIS APPLIANCE MUST BE EARTHED
Check that the voltage stamped on the rating label of your fire is the same as your house
electricity supply which must be AC (alternating current).
The mains cord of the fire has a UK type plug fitted with a 13amp fuse. When replacing a
fuse, use a 13amp fuse approved to BS 1362. The fuse cover of a moulded on plug must
be refitted when changing the fuse; should it be lost the plug must not be used until the
correct replacement fuse cover is obtained from your service agent or the plug is
replaced.
The wires in the mains supply cord are coloured in accordance with the following code:
Green and Yellow = Earth, Blue = Neutral, Brown = Live.
If your fire is fitted with a moulded on mains plug which is not suitable for the socket
outlets in your home, the plug must be cut off and an appropriate one fitted.
Note: A plug cut off from a flexible cord will give a shock hazard if inserted in a 13 amp
socket elsewhere in the house. To avoid this it should be disposed of immediately.
If you are fitting an alternative type of plug then the colours of the wires in the mains cord
may not correspond with the identifying markings on the plug terminals. In this case
proceed as follows:
The wire which is coloured Green/Yellow must be connected to the terminal in the plug
which is marked by the letter E or by the earth symbol or coloured Green or Green/
Yellow. The wire which is coloured Blue must be connected to the terminal in the plug
which is marked by the letter N or coloured Black. The wire which is coloured Brown must
be connected to the terminal in the plug which is marked by the letter L or coloured Red.
All Fires must be connected to a readily accessible isolating socket regardless of
whether they are free standing or fixed into a surround; fixed installations must
also be fused.