FUEL BED LAYOUT (continued)
3. Open the bag of 16 moulded coals. All of the coals are the same.
Take five coals and place them as shown. Care should be taken to
ensure that the coals bridge the gap between the front coal and the
four coal supports at the front of the matrix. Care should also be
taken not to push the coals right down between the coal supports,
as this can detract from the flame picture when the appliance is run-
ning.
4. Take five more moulded coals and position as shown to form the
‘second row’ of the fuel effect. The coals may be rotated as desired
to fit into the gaps between the coal supports in order to create a
random, realistic effect. Again, remember not to push the coals
down too far into the valleys between the coal supports as this can
have a detrimental effect to the flame picture.
5. Now take another four coals and place behind the second row of
coals, in order to complete the third row. The coals may be orien-
tated as desired to achieve a realistic effect. Keep the spacing
between the coals even and uniform. The two coals at the ends of
the row may be placed rearwards, towards the back corners of the
fuel matrix.
6. Finally, take the two remaining coals and place at the back of the
fuel matrix, in the centre as shown. Adding these coals should com-
plete the appearance of the fuel bed giving an even distribution of
equally spaced coals.
The fire is designed to operate correctly with the coals supplied
when assembled according to the instructions. Never add to the six-
teen coals, or change them for a different type. Never throw rubbish
or other matter onto the coal bed.
FUEL BED LAYOUT
(pebble effect option)
1. Refer back to section 5.0 - Fuel bed layout (coal effect option) and
follow steps 1 and 2. The front strip and fuel effect matrix used for
pebble effect versions are of the same design as coal effect versions,
but have a different surface finish.
3
5.1
5.0
© 2009 Pure Glow Limited
Содержание ANNABELLE
Страница 19: ......
