Section Three: Install the LED Soft Strip with B90 Connectors (side mount)
4:
Attach the assembled trap door frame to the junction box
using the #4-40 screws.
NOTE:
Refer to Section Three in the TruLine 1A Channel and
Lens instructions to plaster before continuing.
1:
Insert the male-to-male power adapter to each power
connector.
2:
Connect the L-Shaped Flexible Power Connectors to each
male-to-male power adapter.
L-SHAPED
FLEXIBLE
CONNECTOR
POWER
ADAPTER
NOTE:
Omit this section if using the Snap & Light connector
(LC-SLC) with Standard Soft Strip. Refer to Section Four.
3:
Place the assembled power connections onto the channel
where the LED soft strips will be installed.
NOTE:
For side mount installations, discard the trap door.
3
4:
Carefully remove the backing from the LED strip, making sure not to remove the tape from the LED strip. Line up the red
wire side of the power connector with the "+24VDC" marking on the LED strip. Push the male connector of the LED strip into
the L-Shaped Flexible Power Connector.
5:
Firmly press down the adhesive portion of the LED strip onto the side mount channel surface while removing the rest of the
backing, making sure there are no air bubbles that can cause surface irregularities.
6:
Repeat steps 3 through 5 for the other LED strip on the other side of the channel. Ensure that the Flexible Connectors are on
opposite corners from each other to avoid dark spots.
K
L
M
2
SIDE
MOUNT
SIDE
MOUNT
SIDE
MOUNT
SIDE
MOUNT
1
3
L-SHAPED
FLEXIBLE
CONNECTOR
PAPER BACKING
LED STRIP
LED STRIP
4
5
6
TRAP DOOR
FRAME
#4-40
SCREW
4
NOTE:
Center Feed Power Channel could feed the strip one or
both directions. When using to feed one direction, then discard
the other connector.
J
