PureEdge Lighting TruLine 1A Скачать руководство пользователя страница 4

Страница: 4 / 6

Place the Snap & Light connector into the channel where the LED soft strip will be installed.

Insert the LED strip into the Snap & Light connector so that the "+24VDC" mark on the strip is aligned with the red wires.

Ensure the LED strip contacts align fully with the contact pins. Push the LED strip completely into the contact pins.

Firmly press down the adhesive portion of the LED strip onto the side mount channel surface while removing the rest of the

backing, making sure there are no air bubbles that can cause surface irregularities.

Repeat steps 1 through 3 for the other LED strip on the other side of the channel. Ensure that the Snap & Light Connectors

are on opposite corners from each other to avoid dark spots.

Section Four: Install the Standard LED Soft Strip with Solderless Snap &
Light Connector (LC-SLC) (side mount)

Section Five: Install LED Soft Strip on the Bottom of Channel

NOTE:

Do not cut the trap door.

Use pliers to bend the large section of the trap door cover to allow for access to power connections.

DO NOT CUT

BEND HERE

NOTE:

This product can be used as a combination of side and

bottom mount.

Attach the bent trap door to the Center Feed Power

Connector with the provided screw.

TRAP
DOOR

SNAP & LIGHT
CONNECTOR

LED STRIP

#4-40
SCREW

TRAP
DOOR

SIDE

MOUNT

SIDE
MOUNT

Содержание TruLine 1A






