4" CANOPY
COAXIAL
CABLES
3
CORD
GRIP
PHILLIPS
SCREW
14
14:
Tighten the two Phillips screws on the sliding post to
secure it to the channel.
H
NOTE:
If cable is curled or kinked, straighten by holding between the shaft of a screwdriver and thumb and pulling the cable
through (see inset).
KNURLED
NUT
2" CANOPY
CORD GRIP
ASSEMBLY
COAXIAL
CABLES
1
I
1:
Split the end of the coaxial cables coming from the End Cap Power Connector.
2:
For the 2" canopy, feed the cables through the knurled nut, 2" canopy and cord grip assembly respectively.
3:
For the 4" canopy, feed the cables through the cord grip of the canopy.
4:
Use the 18AWG hole of the wire stripper to remove 1-3/8"
of the outer insulation to expose the braided wire.
5:
Use the 18AWG hole of the wire stripper to remove 1" of
the braided wire making sure not to nick the inner wire
insulation.
6:
Use the 20AWG hole of the wire stripper to remove 1/8" of
the inner insulated wire.
NOTE:
Scan the QR Code to watch the video clip of
the following steps or visit
http://www.edgelighting.com/videos/cxc_connector/
BRAIDED
WIRE
INNER
INSULATION
BARE
WIRE
1/8"
OUTER
INSULATION
1"
3/8"
COAXIAL CABLE
J
COAXIAL
CABLE
4
5
WIRE
STRIPPER
6
3
Section Two: Installing the Canopy
2
NOTE:
Omit this section if the connector does not come with a 2" or 4" Canopy. Refer to the other surface mount power canopies
instructions provided with the product.
