C
CHANNEL
END CAP
#4-40 SET
SCREW
5:
Push the channel assembly onto the joiners and male pins of
the End Cap Power Connector until they are properly mated.
6:
Secure the channel by tightening the two #4-40 set screws
using a 0.05" Allen wrench.
7:
Install the lenses and optional louver to the assembled
channel.
D
PHILLIPS
SCREW
SLIDING
POST
8
8:
Remove the two Phillips screws from the sliding post.
9:
Place the back part of the sliding post inside the back of the
channel and rotate it into place.
10:
Place the other part of the sliding post onto the back of the
channel.
11:
Ensure that the power cables are in between the two parts
of the sliding post.
POWER
CABLES
CHANNEL
11
10
SLIDING
POST
SLIDING
POST
F
2
5
6
JOINER
9
G
HOLD
CABLES
HERE
SLIDING
POST
12
13
12:
Insert the two Phillips screws halfway into the sliding post
to loosely join the two parts.
13:
Adjust the position of the sliding post by moving it across
the channel.
WARNING:
To avoid damaging the coaxial cables electrical
connections, make sure that the end of the coaxial cables coming
out of the fixture is held with thumb before relocating sliding
post.
POWER
CABLES
PHILLIPS
SCREW
E
CHANNEL
SLIDING
POST
9
