2
Prepare Power Cable and Install Cable Grip
1:
Feed the coaxial cable through the knurled nut, 2" canopy
and cable grip assembly respectively. Press the tab on the
cable grip to feed the cable through.
NOTE:
If cable is curled or kinked, straighten by holding
between the shaft of a screwdriver and thumb and pulling the
cable through (see inset).
KNURLED
NUT
CANOPY
TAB
CABLE GRIP
ASSEMBLY
COAXIAL
CABLE
1
BRAIDED
WIRE
INNER
INSULATION
BARE
WIRE
1/8"
OUTER
INSULATION
1"
3/8"
COAXIAL CABLE
E
COAXIAL
CABLE
2
3
WIRE
STRIPPER
4
2:
Use the 18AWG hole of the wire stripper to remove 1-3/8"
of the outer insulation to expose the braided wire.
3:
Use the 18AWG hole of the wire stripper to remove 1" of
the braided wire making sure not to nick the inner wire
insulation.
4:
Use the 20AWG hole of the wire stripper to remove 1/8" of
the inner insulated wire.
5:
Unscrew the coaxial connector covers and remove from the
connector assembly.
F
CONNECTOR
ASSEMBLY
COAXIAL
CONNECTOR
COVER
COAXIAL
CONNECTOR
COVER
5
D
G
1.5MM ALLEN WRENCH
2MM ALLEN
WRENCH
M4 SET
SCREW
M3 SET
SCREW
6
7
6:
Using the provided 1.5mm Allen wrench, remove the M3
set screw from the coaxial connector assembly.
7:
Using the provided 2mm Allen wrench to loosen (
Do Not
Remove
) the M4 set screw.
COAXIAL
CONNECTOR
COVER
BRAIDED
WIRE
8:
Slide the connector cover over the coaxial cable.
9:
Place the ferrule over the 3/8" braided wire of the coaxial
cable.
H
FERRULE
8
9
NOTE:
Scan the QR Code to watch the video clip of
the following steps or visit
https://www.PureEdgeLighting.com/video_feed/
installation_cxc_connector
