02
03
PureAiro
DSC 120ES
INSTALLATION
Place dehumidifier on a level surface.
Do not place unit directly on vapor barrier. For example, use blocks or pavers to create a
level surface.
1
2
Set up the drain line
Plug dehumidifier into grounded 15 amp circuit.
Remove the compression nut and slide it over the end of the hose to be attached to unit.
WARRANTY REGISTRATION
SPECIFICATIONS
Your dehumidifer comes with an extensive warranty.
For future reference, write down the model, serial number, and date of purchase for your
dehumidifier. This information is necessary for seeking assistance in the future and can be
found on the data label on the side of the unit.
Fdca adtora qestors cncemin your diridte. cnatyor
local nsaller or call PureAiro at +44(20)81247965
Model Number:
Serial Number:
Date Of Purchase:
IMPORTANT NOTES
PureAiro DSC 120C
3
Do not use the dehumidifier in standing water. If there is a chance that the dehumidifier
has been flooded, unplug the unit, remove the cover, and allow it to dry completely before
proceeding.
Do not insert objects or your fingers into the inlet or discharge.
Your dehumidifier should only be repaired by a qualified technician.
Unless otherwise noted, all maintenance should be done with the unit powered off.
Always connect your dehumidifier using a grounded electrical connection(as required for
all electrical appliances). The use of non-grounded wiring will void the warranty.
Do not use water to clean the exterior of the dehumidifier. To clean unit,unplug from
power, then use a damp cloth to wipe the exterior.
Do not stand on dehumidifier or place objects on it.
Do not use with extension cord or plug adapter.
Airflow :
350 m³/H
Operating Temp. Range:
3-40
℃
Operating Relative Humidity Range:
36%-90%
COP:
3.5 L/kWh
Refrigerant:
R410A
Amperage Usage:
6 Amps
Power Supply:
230V / 50Hz / Single Phase
Outlet Requirement:
15 Amp
Sound Level:
60 dBa
Dimensions L x W x H:
600 x 360 x 430mm
If unit has been turned or flipped so that the compressor did not remain upright, place the
unit on a level surface and wait a minimum of 2 hours before proceeding.
Slide the side of hose with compression nut over the insert on the compression fitting
completely.
Tighten compression nut.
INSTALLATION REQUIREMENTS
The area where the dehumidifier is located should be sealed with a vapor barrier.
If the unit is installed in a crawl space, all vents should be sealed.
For proper ventilation, neither the inlet or discharge should be positioned against a wall.
The inlet needs a minimum of 12" clearance and the discharge requires a minimum of
36" clearance.
For the best air diffusion, install the unit so that a side panel faces the wall.
PureAiro dehumidifiers are only intended for operation when the unit is upright and level
with the feet on the ground.
HOW IT WORKS
PureAiro dehumidifiers use an integrated humidistat to monitor theconditioned space.
When the relative humidity goes above the selected setpoint, the dehumidifier will energize.
Air is then drawn across an evaporator coil, which is cooler than the dew point of air. This
means moisture will condense out of the air. The air is then reheated through the condenser
coil and distributed back into the room.
Capacity @ 30
℃
/80%RH:
100 L/Day
Capacity @ 27
℃
/60%RH:
60 L/Day
