Pure Water MINI CLASSIC CT, Руководство пользователя

Страница: 9 / 16

9
First Time Start-Up Continued...
8. Plug the power cord into the back of the machine and
then into the electrical source.
9. Turn the power switch (11) to the ON position.
10. Press and release the “Start Cycle” Switch.
11. Allow the unit to operate until it automatically shuts off
(approximately 3.5 hours).
12. Keep the first batch of distilled water for soaking the post
filter, but do not drink.
13. Submerge the filter (8) completely in a separate small
container with distilled water for one minute, flip the filter
several times.. Remove the filter (8) and place inside the
filter housing (9).
14. Slide the filter housing (9) into the guide above the drink -
ing water container.
15. Replace the drinking water container (10) to the distiller.
NORMAL OPERATION
1. Ensure that the boiling chamber is cool.
2. Open the door (5) and remove the boiling chamber (1) by
pulling on the handle.
3. Loosen the black knob on the lid (4) and slide the lid from
side to side and lift the lid out.
4. Swirl and empty out any water left in the boiling chamber (1)
from the prior batch.
5. Fill the boiling chamber (1) with tap water until it touches the
bottom of the water level indicator (2).
6. Place the lid (4) on the boiling chamber (1). Tighten the black
lid knob firmly, ensuring a good seal. DO NOT overtighten.
7. Push the boiling chamber (1) into the left side of the distiller
until it fits snug and clears the blue decal. Close the door.
8. Be sure lid is removed from container. Put the drinking water
container (10) in place.
9. Turn the power switch (11) to the ON position.
10. Press and release the “Start Cycle” Switch.
11. Allow the unit to operate until it automatically shuts off. This
will take approximately 3.5 hours and will produce approxi-
mately 3 liters of distilled water.
CAUTION: Never open the door during operation and never
remove the boiling chamber while the unit is operating.