SAFE USAGE OF THE PROJECTOR
The following points are important for safety as well as for the smooth installation and
performance of the unit.
When unpacking and before disposing of the package check there is no transportation
damage before using the projector. Should there be any damage caused by transportation,
consult your dealer and do not use the unit. Keep the package well for your possible future
transportation.
The projector is intended for outdoor use and is rated at IP44. Install only in level locations.
Keep this device away from dry and excessive moisture.
The projector is not designed or intended to be mounted onto inflammable surfaces.
The projector is only intended for installation, operation and maintenance by qualified
personnel.
The projector must be installed in a location with adequate ventilation, at least 50cm from
adjacent surfaces. Be sure that all the cooling fans run normally and no ventilation slots are
blocked.
Do not project the beam onto inflammable surfaces, minimum distance is 5m.
5m
Avoid direct exposure to the light from the lamp. The light is harmful to the eye.
Do not attempt to dismantle and / or modify the projector in any way.
Electrical connection must only be carried out by qualified personnel.
Before installation, ensure that the voltage and frequency of power supply match the power
requirements of the projector. Only use the lamp with the specified type and rating.
It is essential that each projector is correctly earthed and that electrical installation
conforms to all relevant standards.
Do not connect this device to any dimmer pack.
Make sure that the power-cord is never crimped or damaged by sharp edges. Never let the
power-cord come into contact with other cables. Only handle the power-cord by the plug.
Never pull out the plug by tugging the power-cord.
Keep the lamp clean. Do not touch the lamp glass with bare hands.
The lamp used in this projector is a high power discharge lamp. After being switched off
don’t attempt to restart the projector until the lamp has cooled, this will require approx 15
minutes. Switching the lamp on and off at short intervals will reduce the life of both the lamp
and the projector. Occasional breaks in operation will prolong the life of both the lamp and
the projector.
Never run the projector without a lamp.
There are no user serviceable parts inside the projector, do not open the housing and never
operate the projector with the covers removed.
Always disconnect from the mains, when the device is not in use or before cleaning it
or before attempting any maintenance work.
If you have any questions, don’t hesitate to consult your dealer.
3/14
Century Colour 2500L EN.doc
