INSTALLATION OF PR20.0 AIR CLEANER
EQUIPMENT:
1.
Each PR20.0 unit is equipped with two (2) eye bolts, two (2) eye lags and industrial
hanging wire for easy installation.
2.
The PR20.0 has a ten foot power cord and a three prong grounded plug. Electrical: 120
Volts, 9 Amps.
3.
Each unit includes a years supply of filters, which consists of twelve (12) pre-filters, one
(1) V-Bank charcoal filter and one (1) H.E.P.A. filter.
INSTALLATION:
Step 1
. Remove the system from the shipping container. Remove the adjustable louver door
from inside the system. After you have removed the adjustable louver door, remove the
industrial staples and the H.E.P.A. bar and then slip out the H.E.P.A. filter. The H.E.P.A. filter is a
pleated media surface with a particle board frame. Removing the H.E.P.A. filter will make the
system lighter for installation purposes.
Step 2
. On either side of the system there are two mounting holes where the eye bolts are
inserted. It is easiest to screw the eye bolts into these mounting holes before mounting into the
ceiling. If the area above the drop ceiling is tight for space, then you may need to put the eye
bolts in the mounting holes after you have the system into the drop ceiling.
Step 3
. Remove the ceiling tile(s). The system will fit into either one 2’x 4’ or two 2’x 2’ tiles.
Step 4
. A system being installed into a drop ceiling that has joints, steel girders or exposed
beams above can be hung without the eye lags (see step 5). At least one eye lag will be needed
if your system is being installed into a ceiling that is solid above (see step 6).
Step 5
. Locate either a joist, girder or beam that is directly above the tile where your system will
be installed. After you have located a joist, girder or beam, drape the industrial hanging wire
over the apparatus so that either side is evenly dispersed. Line up the eye bolts with the hanging
wire so they are vertical. Thread one end of the hanging wire through one of the eye bolts, loop
the wire and twist tightly together. Thread the opposite end of the hanging wire through the
opposite eye bolt. Pull the wire tight. The system should be only slightly resting on the grid work
of the drop ceiling. After you have adjusted the weight of the system on the grid work, then loop
the wire and twist tightly together.
Step 6
. Locate a stud in the solid ceiling that is directly above the tile where the system will be
installed. Fasten the eye lag into the stud making sure to line up the eye lag with the eye bolts
on the system so the hanging wire will hang vertically. Thread the hanging wire through the eye
lag so that either side is evenly dispersed. Thread one end of the hanging wire through one eye
