WARNING-
Do
NOT
add chemicals to the pool/spa directly in front
of pump suction. Adding chemicals may damage pump and void your warranty
.
WARNING-
BEFORE
removing strainer cover
1.
STOP
pump
2.
CLOSE
valves in suction and outlet
3.
RELEASE
pressure from pump and piping systems using the filter manual air
relief valve.
Priming Pump
WARNING-
Keep all suction and discharge valves OPEN, as well
as the filter air relief valve on filter when starting your pump. Failure to do so can result
in severe personal injury.
● Release all pressure from the filter, pump, and piping system.
● If the water source is higher than the pump, the pump will prime itself when the
suction and outlet valves are open. If the water source is lower than the
pump,unscrew and remove the strainer cover and fill it with water.
● Inspect, clean, and lubricate the strainer o-ring each time it is removed.
● Replace the strainer cover on housing, turning clockwise to tighten.
Turn on pump and wait for the pump to prime. This typically can take up to five minutes.
The vertical length of suction lift and horizontal length of suction pipe affects the overall
priming time. If the pump does not prime in five minutes, stop motor and troubleshoot
unit. Make sure all suction and discharge valves are open when the pump is running.
PURELINEPOOL.COM
TEL: 407-834-2200
12
