Pure Fitness 8534FB, Руководство пользователя

Страница: 11 / 17

STEP 3: ASSEMBLE PEDALS
Locate 2x Foot Pedals (9 L/R).
On many models the hardware to attach the pedals will come threaded to each Ped-
al. For part clarification, or if this hardware is not attached to the Pedals, locate the following additional parts
: 2x Large
Bearings (40), 2x Large Bushings (48), 2x Large Washers (51), 2x Spring Washers (45), 2x M10 Hex
Nuts (56).
A.
Slide 1x Large Metal Bearing (40) onto the bolt extending from the Pedal with the wider end
against the Pedal. Next, take the “C” clamp end of the Connection Plate (12) and slide it onto the
smaller edge of the Large Bearing. On the other side of the Connection Plate, first slide 1x Large Flat
Washer (51), and then 1x Large Bushing. Thread this completed assembly into the hole in the Pedal
Crank. Use the Multi-Hex Wrench to turn the flat edges of the Pedal Screw assembly so it extends
from the other side of the Pedal Crank. See diagram on above right for clarification.
WARNING: You must assemble the Pedal hardware in the order shown above to prevent accidental
injury and/or damage to the Fan Bike due to the Connection Plate separating from the Pedal.
B.
Secure the Pedal Assembly with a Spring Washer and M10 Nut.
Repeat the above steps to assemble the other Pedal.
Note: The threading for these Pedals are the same as found in a bicycle. As such, one of the Pedals
will need to be rotated to the LEFT to tighten.
Pedal Crank
Lg. Bushing
Washer
Conn. Plate
Lg. Bearing
Wrench
PEDAL
Meijer.com