WARNING!
Electric shock hazard. DISCONNECT power before servicing.
UNPACKING
Inspect this unit before beginning installation. Occasionally, products are damaged during shipment. If any
components are damaged, contact PumpSpy
™
at (833) 786-7779 for assistance.
1. Unplug the cellular controller from AC power.
2. Disconnect all connections from the back of the cellular controller.
3. Open the battery case and disconnect the battery leads from the battery. Dispose of the cellular control box and the
affixed battery case lid.
4. Connect the battery leads from the WiFi controller to the battery. Secure the battery case lid to the existing battery case
bottom.
5. Connect the included adapter to the end of your backup pump’s power cable. Then, reconnect all connections to the WiFi
controller.
6. Plug the WiFI controller into AC power.
TEST THE SYSTEM IN THIS ORDER! IT’S RECOMMENDED TO RUN INITIAL CYCLES WITH WATER AND CHECK ALL
PLUMBING FOR LEAKS DURING TESTING.
Lift the lowest Battery Backup switch and hold. Release when the battery backup pump cycles. The BACKUP PUMP
status LED will remain GREEN. The MAIN PUMP status LED will turn RED and the alarm will sound. Press ALARM MUTE
to silence, if desired.
REFILL BASIN WITH WATER.
Cycle the Primary Sump Pump. The alarm will stop and the MAIN PUMP status LED will turn GREEN.
CONNECT TO A WIFI NETWORK.
Download the PumpSpy app from the App Store or Google Play. Follow the on-screen
instructions to connect to a WiFi network.
The WiFi status LED will turn GREEN after completing the WiFi setup with the
PumpSpy app.
INSTALLATION
The PumpSpy System requires a 12V Deep Cycle Battery with a minimum 40 AMP/HR
rating, 75 AMP/HR rating (or higher) recommended. AGM Battery is strongly recommended.
