9
The PA66AMP/KIT can work with speakers that are 4-8 Ohm. There are
two modes that can be set for different setups: Stereo or Bridge. An 8 Ohm
speaker can only be used when in Bridge mode. To choose between modes,
use the mode switch to determine modes for each zone (Number 2 Panel
Descriptions, page 5)
Once you have properly identified the desired mode, strip about ¼” of
insulation and twist the copper strands. Connect the speaker wire to there
screw down terminal as indicated on the amp. To loosen the terminal turn
counterclockwise and to tighten the terminal turn clockwise. For better
quality, we recommend used 12-14 AWG stranded copper speaker wire.
CONNECTING THE SPEAKERS
USING THE PRE-AMP OUTPUTS
There are 3 unbalanced, line level Pre-Amp outputs that correspond to the
first 3 Outputs. These can be used to connect an additional amplifier, expand
zones, or to connect a powered subwoofer. The Pre-amp output levels are not
fixed and are able to be controlled via IR, RS232, keypads (PA66KIT) and Wifi.