1 0
CONNECTING THE KEYPADS
The PA66KIT comes with 6 POE enabled keypads. This allows for source
control from each specific zone as well as IR routing to the appropriate source
devices once selected. The PA66KIT also comes with a hub that allows for all
6-keypads to be connected to the amp via Cat5e/6.
Without power being connected, connect a Cat5e/6 cable
to the RJ45 port labeled KEYPADS on the back of the
PA66AMP/KIT. We recommend terminating the Cat5e/6
using the 568B standard.
At this point it is also important to address your keypads. Refer to the chart
below which is also found on the PCB board of the back of the keypad to set
the dip switches according to the zone you would like it to control.