Pulse Secure MAG2600, Руководство по оборудованию

Страница: 59 / 86

MAG Series Pulse Secure Gateways Hardware Guide
© 2016 Pulse Secure, LLC., All rights reserved. 59
Connecting to a Management Console
The Pulse Secure Gateway devices have a console port with an RJ-45 connector. Use the console port to
connect the device to a management console or to a console server.
Connect each service module to a management console before powering up the Pulse Secure Gateway.
To connect a Pulse Secure Gateway to a management console:
1. Connect one end of the cable to the console port labeled CONSOLE on the Pulse Secure Gateway.
2. Connect the other end of the cable into the console server or management console:
When you connect a management console before powering up the Pulse Secure Gateway, you should see
a message similar to this:
Please select a factory-reset personality:
[1] Pulse Secure Access Service 7.1 R1
[2] Pulse Access Control Service 4.1 R1
Choice:
If you do not see this message, make sure the management console is connected, and then cycle the power
on the Pulse Secure Gateway.