Pulse Secure MAG2600, Руководство по оборудованию

Страница: 37 / 86

© 2016 Pulse Secure, LLC., All rights reserved. 37
MAG Series Pulse Secure Gateways Hardware Guide
3. Taking care not to touch power supply pins, leads, or solder connections, remove the power supply
from the bag.
4. Using both hands, place the power supply in the power supply slot on the rear panel of the chassis, and
slide it in until it is fully seated. You will hear a distinct click when the power supply is fully seated in the
chassis.
Installing a Fan Assembly in the MAG6610 and MAG6611
The fan tray is a hot-insertable and hot-removable field-replaceable unit (FRU) for the MAG6610 and MAG6611.
You can remove and replace the fan tray while the Pulse Secure Gateway is running without turning off the
power to the Pulse Secure Gateway. Fans are located on the back of the Pulse Secure Gateway chassis.
NOTE: On the MAG6611, service modules are paired with fan trays and hard drives. When moving a service
module to a different slot, you must move the associated fan trays and hard drives to the new location as well.
Before you install a fan try in the Pulse Secure Gateway, make sure that you understand how to prevent ESD
damage.
To install a fan tray in a Pulse Secure Gateway MAG6610 or MAG6611:
1. Attach the electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to the
ESD point on the chassis.
2. Remove the fan tray blank panel where you intend to install the fan tray.
3. Hold the handles of the fan tray, and align the tray with the fan tray guides on the fan tray slot.
4. Slide in the fan tray until it is fully seated in the chassis.
Installing a Hard Drive in the MAG6610 or MAG6611
The hard drive is a hot-insertable and hot-removable field-replaceable unit (FRU) on the MAG-SM360 only.
NOTE: Service modules are paired with fan trays and hard drives. When moving a service module to a different
slot, you must move the associated fan trays and hard drives to the new location as well.
The MAG-SM160 uses only one hard drive. The hard drive and service module are mated together through
the chassis midplane. When replacing the hard drive, insert the drive in either the upper or lower slot where
the service module is located. A drive cover should be placed over the unused slot to maintain proper airflow.
To install a hard drive in a Pulse Secure Gateway:
1. Press the lever release button on the front of the hard drive carrier, and extend the lever to its fully
open position.
2. Slide the hard drive carrier assembly into the slot until it stops. Do not push the drive into the slot any
farther.