Pulsar TC-10B, Руководство пользователя

Страница: 78 / 190

Page 7–2 October 2003
TC–10B System Manual
Technologies, Inc.
7.2.6 Universal Receiver Module
J3 N.O. (margin relay)
7.2.7 Receiver Output Module
JU1 Set to dc supply voltage
JU2 Set to dc supply voltage
7.2.8 Universal Checkback Module
(if supplied)
The DIP switch, labeled "SW3", is on the bottom
left of the Module's PC board. The module reads
the switch's setting at power-up to determine its
configuration. Any changes to the switch's setting
after power-up are ignored until you turn the
power off and on again.
Using Table 7-2 as a guide, set the DIP switch to
the desired setting. Note that only S1-S3 are used;
S4 is reserved for future use. To set S1-S3, put
them in the up position for OFF and the down
position for ON. You can set the DIP switch to one
of five possible configurations. All other switch
combinations (of S1-S3) are invalid. If you
mistakenly set a different combination, the
module assumes the "CUSTOM" mode.
If you set the DIP switch to one of the factory
preset settings, the module is locked into that
configuration. You cannot customize the settings.
For descriptions of the individual settings, please
see the "Configuration Settings" section in chapter
16.
If you set the DIP switch to the "CUSTOM"
option, you can use your PC or laptop to configure
the module any way you want. (See "Using your
PC to Communicate with the Universal
Checkback Module" for complete configuration
instructions.)
7.2.9 Optional Voice Adapter Module
(if supplied)
JMP1 N.O. / N.C.Alarm contact
SW1-1 Off (Up) TCF-10B
SW1-2 On (Down) TC-10B
SW1-3 On (Down) TC-10B
SW1-4 On (Down) Either
S1 S2 S3 Settings Option
off off off Custom Settings Enabled
on off off Factory Preset #1 Settings
off on off Factory Preset #2 Settings
on on off Factory Preset #3 Settings
off off on Factory Preset #4 Settings
Table 7–2. Universal Checkback Module DIP Switch Settings.