RSUPS98R
RACK POWER
7
2.2. Installation procedure.
1. Before installation, cut off the voltage in the 230V power-supply circuit.
2. Mount the power supply in a RACK 19" cabinet as shown below:
- Mount M6 cage nuts
- Secure the enclosure with 4xM6 screws
3. Connect the batteries in series/parallel to the + BAT- terminals:
- battery output (V+): terminal BAT+
- battery output (V-): terminal BAT-
4. Connect the ~230V AC power cord with the IEC C13 plug (included) to the 230V AC power supply and turn on
the power (~230V).
5. Connect the camera cables to the RJ45 connectors (PoE connectors) and connect the recorder to the network
(the UPLINK connector).
6. Connect the power supply of the DVR (by default, the device is equipped with a cable terminated with the DC 2.1
/ 5.5 plug).
7. Make the following technical connections when needed:
ALARM
– technical output of collective failure indication
8. Check the optical indication of the switch operation.
3. Indication of the device operation.
3.1. LED indication of operating status.
The PSU has 6 LED lights at the front panel:
GREEN LED:
on
– the PSU is supplied with 230V AC
off
– no 230V AC supply
GREEN LED:
on
– DC voltage at the output of the switch mode PSU
off
– no DC voltage at the output of the switch mode PSU
RED LED:
on
– failure
off
– no failure
RED LED:
ON
– too high temperature of the switch mode power supply
(>70°C)
OFF
– standard temperature of the switch mode power supply
RED LED:
on
– battery voltage <23V
off
– battery voltage >23V
GREEN LED:
ON
– DC voltage at the NVR output
OFF - no DC voltage at the NVR output
