www.pulsar.pl
PSDCB161220E
GREEN POWER CCTV
8
4. Operation and use.
4.1 Overload or short circuit of the PSU output (SCP on)
The
AUX1÷AUX16
outputs of the fuse modules are protected against short circuits by melting fuses. In case of
fuse damage, the replacement of the same parameters is required.
In case of overload, the output voltage is automatically shut off, and so is the LED indicator. The restoration of
the voltage takes place immediately after the failure (overload) is over.
4.2 Battery-assisted operation.
The PSU is equipped with the discharged battery disconnection system. During the battery-assisted operation,
reducing voltage below 9,5V at the battery terminals will cause battery disconnection.
4.3 Maintenance.
Any and all maintenance operations may be performed following the disconnection of the PSU from the power
supply network. The PSU does not require performing any specific maintenance measures, however, in case of
significant dust rate, its interior is recommended to be cleaned with compressed air. In case of fuse replacement, use a
replacement of the same parameters.
WEEE MARK
According to the EU WEE Directive – It is required not to dispose of electric or electronic
waste as unsorted municipal waste and to collect such WEEE separately.
The power supply unit is adapted for a sealed lead-acid battery (SLA). After the operation period it must not be disposed of but recycled
according to the applicable law.
Pulsar
Siedlec 150, 32-744 Łapczyca, Poland
Tel. (+48) 14-610-19-40, Fax. (+48) 14-610-19-50