Pulsar PG4500iSR, Руководство оператора

Страница: 12 / 50

12
• Place generator on a firm level surface.
• Unclip and remove the oil service panel to access
the oil fill/dipstick.
CAUTION!
ASSEMBLY
•
•
Insert a funnel into the crankcase dipstick hole and carefully add the specified amount of engine oil (SAE 10W-30) to
empty reservoir until or oil reaches the outer edge of the oil fill hole (crankcase dipstick hole).
Be sure to replace dipstick and tighten securely before attempting to start the engine.
• To check oil, set generator on a firm level surface, unscrew and remove dipstick, wipe dipstick clean,
then reinsert dipstick without re-threading.
• Remove the crankcase dipstick.
Recommended Oil: SAE 10W-30
Oil Capacity: 0.6L (20.2oz)
Checking/Adding Engine Oil
Connecting the Battery
• Unclip the right side panel
• Put the battery into the square hole beside the recoil
handle
• Slide the battery into the until it clicks into place.
NOTE: The electric start generator is equipped with a
battery charging feature. Once the engine is running, a
small charge is supplied to the battery via the battery
tray and will recharge the battery.
Generator has been shipped without engine oil. You must add engine oil before operating this
generator. Always check oil level before each operation.