Pulsar MICROFLOW, Инструкция по эксплуатации, Страница: 23 / 65

Page 17
Velocity Interface
The Terminal strip is detailed as below. There is also a wiring diagram attached
to the board directly underneath the terminal strip. For further information on how
to setup a Velocity Interface unit, please refer to the Velocity Interface user
manual. To set up a
MicroFlow sensor with the Velocity Interface please refer to
Chapter 5 – Setting up your MicroFlow of this manual. The Velocity Interface
manual is also available for download from the Pulsar website:
https://www.pulsar-pm.com/support/downloads/manuals.aspx .
Wire the MicroFlow sensor to the Velocity Interface terminals as follows:
The Green cable (cable screen) should be connected to Earth such as terminal 22
(0V).
Terminal Connection Details
Cable Type
Red
Power
Black
0 volts
Orange
RS485+
(B)
White
RS485-
(A)
Blue
RS485
Common
Terminal no. 23
22 24 25 21
Important Information
If you require help in connecting the MicroFlow to any of the Pulsar
controllers mentioned in this manual, then please contact your local
Pulsar Distributor for assistance.
VELOCITY
SENSOR
RS 485