www.pulsar.pl
INTW
16
5.2 Configuration of power supplies of the PSBEN series with LED display
The PSU fitted with LED display enables setting the communication parameters of the serial port from the
LED panel. To enter the setup mode, simultaneously press the „<,>” rightmost and leftmost buttons on the LED
panel. Depending on the displayed information, the following parameters can be set: „Adr” –
the device address, „trS” – transmission speed, „trP” – transmission parameters.
– simultaneously press the „<,>” rightmost and leftmost buttons on the LED panel
- The „Adr” parameter will be displayed,
- press the right arrow „>”
- The „trS” parameter will be displayed
- press „OK.”
- The display will show one of the two parameters: „9.6” or „19.2” informing
about the selected transmission speed
- use the „<” or „>” buttons in order to set the transmission speed to 19200,
displayed as „19.2”
- confirm by pressing „OK.”
- The „trS” parameter will be displayed again
- press the right arrow „>”
- press "OK" when „trP” is displayed
- The display will show one of the three parameters: „8n2”, „8E1” or „8o1”
- use the „<” or „>” buttons in order to set the „8E1” parameter
- confirm by pressing „OK.”
- Simultaneously press the „<,>” rightmost and leftmost buttons to complete
the configuration procedure
