www.pulsar.pl
INTRE-C
7
6.
„PowerSecurity” web application.
The PowerSecurity web application has been embedded in the INTE-C and INTRE-C communication
interfaces. The programme is a website uploaded from an embedded WWW server which is loaded upon entering
the IP address in the web browser window..
Upon loading the PowerSecurity application, access is gained to the preview of the status of the PSU
connected with an INTE-C interface, or to the preview of all PSUs in the RS485 bus in case of an INTRE-C
interface.
From the WWW browser level, the current status of the PSU can be checked, with preview of such
parameters as output voltages, presence of 230 V supply, or resistance of the battery circuit.
Moreover, the application has an option of interface configuration for the function of remote alerting through email
notification including information on the status of the PSU in case of occurrence of specific events.
4.1 Configuring the connection.
To activate remote communication with the PSU, first setup the connection between the PSU and the
interface, followed by preliminary configuration of the Ethernet INTRE-C module.
The IP address of the module should be entered in the web browser window. The default value is
IP=192.168.1.100.
If the entered IP address is correct, the module login page will be loaded on the browser screen.
Fig. 4. Ethernet module login page.
If the browser does not display the page above, check the Ethernet configuration.
In particular, check the following:
- are the addresses of the network adapters of the computer and router found in the same subnet,
i.e. within the range 192.168.1.0
– 192.168.1.255
- addresses of the network adapters of the computer and router must be different from the address
of the interface, i.e. 192.168.1.100
Appropriate configuration may be performed in the network adapter settings.
Fig. 5. Network adapter settings tab.
