Pulsar dBi 10, Инструкция по эксплуатации

Страница: 50 / 55

DBI (HART) INSTRUCTION MANUAL
50
Password
P921 Enable Code
Enables the passcode ( P922 ), which means the passcode must be entered
to go into program mode. If disabled (set to 0 ), then no passcode is
required, and pressing ESC and ENTER button simultaneously will allow entry
into the program mode.
P922 Passcode
This is the passcode that must be used to enter program mode. The default
is 1997 , but this can be changed to another value.
System Information
P926 Software Revision
This parameter will display the current software revision.
P927 Hardware Revision
This parameter will display the current hardware revision. It is read only and
cannot be changed.
P928 Serial Number
This parameter will display the serial number of the unit.
P930 Factory Defaults
This parameter resets all parameter values to the original Factory Set values
that were installed when the unit was tested, before despatch to you.
To
reset parameters, Set P930 to 1.
Date & Time
The date and time are used, to control specific relay functions and date
stamp certain events that are contained in the Data Logs. It is also used in
conjunction with the system watchdog that keeps an eye on the times the
unit has started.
P931 Date
This parameter displays the current date , in the format as set by P933 ( Date
Format ), and can be reset if required.
P932 Time
This parameter displays the current time and can be reset if required, in the
format HH:MM (24-hour format). This is set initially at the factory for UK
time.