EN
6
2) FILLING THE TRANSMISSION
To be filled with EP SAE 80 W 90 oil. Quantity 3L
1.
OIL PLUG
2.
UPPER LIMIT
3.
LOWER LIMIT
4.
THROTTLE LEVER
1
2
3
4~5 cm
6
5
4
7
8
5.
HANDLE
6.
CLUTCH HANDLE
7.
SHIFT LEVER
8.
TANK
3) FILL FUEL TANK
Use fresh clean, unleaded automotive gasoline only.
NOTE :
Do not remove the strainer from fuel tank when filling.
3) ADJUSTMENT OF HANDLE
Loosen the handle knob and select the handle height from the three positions;
Tighten the handle knob after adjustment of handle height.
4) INSTALLATION OF TINES
(1) Install outermost tines (2) to outside of tine holder
(2) The other tines (4) are installed inside of the holder
(3) Cleaning tines (5) should be positioned symmetrically with 150 degrees angle.
(4) Rotary tine shaft should be installed as shown.
(5) Rivet (1) should be installed with hairpin clip (3) not to loosen.
1. RIVET
2. TINES HOLDER
3. HAIRPIN CLIP
4. (12) BI-DIRECTIONAL TINE
5. (2) CLEANING TINE
5) CHECK POINT BEFORE OPERATION
1. Oil quantity inside engine.
2. Fuel quantity inside fuel tank
3. Air cleaner is clean + Air filter oil level
4. Part of air screen on the recoil starter is clean
5. No damage on the fuel hose
6. No damage or dust on the tines
7. No lack of oil on each part
8. No dust/grass on residence stake
9. Shift lever works correctly
10. Engine stops when engine switch turns OFF
11. Clutch lever and engine control lever work correctly
12. Tire pressure
1
2
3
1
5
4
3
