HDMI Matrix Switcher 32x32
PTN Electronics Limited
11
www.PTN-electronics.com
Save[Y].
Save the present operation to the preset
command [Y]. [Y] ranges from 0 to 9.
Recall[Y].
Recall the preset command [Y].
Clear[Y].
Clear the preset command [Y].
Note:
1)
[x1], [x2], [x3] and [x4] are the symbols of input or output channels ranged according
to the model of the matrix switcher. If the symbols exceed the effective range, it
would be taken as a wrong command.
2)
In above commands, “[”and “]” are symbols for easy reading and do not need to be
typed in actual operation.
3)
Please remember to end the commands with the ending symbols “.” and “;”.
4)
Type the command carefully, it is case-sensitive.
Detail Examples
:
1
、
Transfer signals from an input channel to all output channels: [x1]All.
Example:
“3All.” to transfer signals from the input channel No.3 to all output channels.
2
、
Transfer all input signals to the corresponding output channels respectively:
All#.
Example: If this command is carried out on the matrix, the status of it will be: 1->1,
2->2, 3->3, 4-
>4……32->32.
3
、
Switch off all the output channels: All$.
There will be no signals on all the output channels after running this command.
4
、
Check the version of the firmware:
/^Version;
To check the version of the firmware.
5
、
Switch off the detail feedback command from the COM port: /:MessageOff;
Switch off the detail feedback information from the COM port. But, it will leave the
“switch OK” as the feedback, when you switch the matrix.
6
、
Switch on the detail feedback command from the COM port: /:MessageOn;
Switch on the detail feedback information from the COM port. it will show the detail
switch information when send the commands.
7
、
Transfer signals from an input channel to the corresponding output channel:
[x]#.
Ex
ample: “5#.” to transfer signals from the input channel No.5 to the output channel
No.5.
8
、
Switch off an output channel: [x]$.
Example: “5$.” to switch off the output channel No.5.