PTM Cassava Planter, Инструкция по эксплуатации

Страница: 15 / 30

13
Marchesan Implementos e Máquinas Agrícolas “TATU” S.A.
IMPORTANT
Mark the center of chassis, from this mark you have to measure half spacing to right
and half spacing to left, installing in these points the rows.
For making the row spacing change, make this in a clean, plane and stable place.
The planter always should be coupled properly to the tractor.
1 – Lower the parking stands (A), and blocking the planter chassis, to prevent accidents
and several injuries.
2 – Loosen the Nuts (B), from the row lines front fixing, the nuts(C), what fixing the
back of the rows, loosen the bushing bolt (D), what hold the axle close to bearing to displace
whole components of the chassis. Note that these items work aligned, to procedure the
change, the whole assembly moves (See the pictures below).
Spacing between rows
The PTM are delivered with a row spacing to the request number of rows, with flexibility
for several row spacings, sure, if necessary.
Positioning the row units in chassis
Procedures for changing the row spacing
Makes the retighten of the assemblies, with a special attention:
• The retighten of the nuts that hold the rows on main frame should
be maid gradually, avoiding to tight totally at once each nut.
• Between these operations of tightening the nuts of one row and
passing to another row, should be lean the bushing (D), on the
bearing, and just enough tight to the correct align to avoid blocking
the axle.
Setup instructions
B
D
C
A